Oil Pan Sealant Compound
Long story not so short.
Went to change my oil & filter this morning and discovered the oil drain plug 8 mm hex plug was rounded and the 8 mm hex tool would just spin around. Evidently my Porsche dealer service shop over torque the drain plug and ruined it when they were searching for an oil leak early this year. I certainly don't plan to let them touch my car again.
So now I need to remove the pan (13 M6 X 20 torx screws) and remove the drain plug w/ either an easy out or drill it so it falls apart. I can do this while it's on the car but I think it's better dealing w/ the drain plug while the pan is removed. I don't want to get any aluminum chips from the drain plug drilling inside the motor. It's should be a pretty simple task.
No gasket is required but a sealant compound is specified (Porsche #000 043 204 73). I suspect it's just a prema-seal type of sealant (aluminum to aluminum high temperature) but I want to be sure. Does anybody know the details on this Porsche sealant compound or a suggestion on which type I should use?
Thanks for any suggestions or help.
Went to change my oil & filter this morning and discovered the oil drain plug 8 mm hex plug was rounded and the 8 mm hex tool would just spin around. Evidently my Porsche dealer service shop over torque the drain plug and ruined it when they were searching for an oil leak early this year. I certainly don't plan to let them touch my car again.
So now I need to remove the pan (13 M6 X 20 torx screws) and remove the drain plug w/ either an easy out or drill it so it falls apart. I can do this while it's on the car but I think it's better dealing w/ the drain plug while the pan is removed. I don't want to get any aluminum chips from the drain plug drilling inside the motor. It's should be a pretty simple task.
No gasket is required but a sealant compound is specified (Porsche #000 043 204 73). I suspect it's just a prema-seal type of sealant (aluminum to aluminum high temperature) but I want to be sure. Does anybody know the details on this Porsche sealant compound or a suggestion on which type I should use?
Thanks for any suggestions or help.