V1 Hardwire Install....Which wire to tap?
I tried to hardwire my radar yesterday, and came across a problem.....I wanted to tap into the map light, and had read a post on the forum that said the hot wire was the stripey one....well pretty much all my wires were stripey. The two map lights, and dome light are all fed from a single connector (attached to a circuit board) from this connector the wiring harness had brown/red, brown/purple, brown/white & plain brown (can't remember the exact combos....but there were lots of stripes.)
Could someone tell me which one is hot
Many Thanks
Could someone tell me which one is hot
Many Thanks