991 GT3:
If only I knew where I have seen those pictures. Sorry, I cannot remember where I have seen this. It was a series of pictures from Goodwood. (Correct me if I am wrong)This can be a pre production model ofcourse.
Can anybody help me/us with this?
There you go . 991 GT3
997.2 C2S, PDK, -20mm
Guys, ever heard of VTG chargers? I don't want my car to be on fire at some point. Porsche is, to my knowledge, the only car manufacturer to use this technology in a fuel (non Diesel) operated car.
The car doesn't need an engine cover since aerodynamics is quite impressive and the best for it's class at higher speeds (no kidding). As soon as I put my hands on the technical documentation, I will post more details about that.
Regarding the tire "mole": This particular issue has been addressed with Pirelli quality control, so it won't happen again.
--
RC (Germany) - Rennteam Editor Porsche 991 Turbo S, Cayenne GTS (958), BMW X3 35d (2013)
JimFlat6:
Turbo S is a lot of money, there should be no interior trim identity issues and they shouldn't just merrily throw a cosmetically blemished tire onto a new $$$$$$$ car either. Also look at the image that shows the "road" side of the engine. The electrical wire lead, its plug and receptacle are not covered by a boot. Its just left exposed to the elements. Dumb.
The tire is not really an issue, this happens pretty often and Pirelli is to blame, not Porsche. Pirelli guarantees a certain quality and Porsche just makes random quality checks on supplier parts as far as I know. This is a procedure similar to most car manufacturers worldwide.
The "open" electrical wire lead is, according to the information I got, no issue. Before something hits the wire lead, it will hit metal and/or a rubber duct before that , so no issue here. The part itself needs to be easily accessible.
No 911 Turbo has an engine cover, not even the very expensive 997 GT2 RS. Never has been an issue, aerodynamics are just fine and damage is unlikely, unless you lower the car (which of course isn't really recommended).
--
RC (Germany) - Rennteam Editor Porsche 991 Turbo S, Cayenne GTS (958), BMW X3 35d (2013)
reginos:
RC:Regarding the tire "mole": This particular issue has been addressed with Pirelli quality control, so it won't happen again.
Will they replace both on the axle FOC?
--
"Form follows function"
There is no need for replacement, the "mole" has no safety impact at all (and no, this doesn't come from my dealer, I wouldn't trust them with such information).
RC (Germany) - Rennteam Editor Porsche 991 Turbo S, Cayenne GTS (958), BMW X3 35d (2013)
Oct 11, 2013 4:31:08 PM
RC:
JimFlat6:
Turbo S is a lot of money, there should be no interior trim identity issues and they shouldn't just merrily throw a cosmetically blemished tire onto a new $$$$$$$ car either. Also look at the image that shows the "road" side of the engine. The electrical wire lead, its plug and receptacle are not covered by a boot. Its just left exposed to the elements. Dumb.
The tire is not really an issue, this happens pretty often and Pirelli is to blame, not Porsche. Pirelli guarantees a certain quality and Porsche just makes random quality checks on supplier parts as far as I know. This is a procedure similar to most car manufacturers worldwide.
The "open" electrical wire lead is, according to the information I got, no issue. Before something hits the wire lead, it will hit metal and/or a rubber duct before that , so no issue here. The part itself needs to be easily accessible.
No 911 Turbo has an engine cover, not even the very expensive 997 GT2 RS. Never has been an issue, aerodynamics are just fine and damage is unlikely, unless you lower the car (which of course isn't really recommended).
--
RC (Germany) - Rennteam Editor Porsche 991 Turbo S, Cayenne GTS (958), BMW X3 35d (2013)
The aerodynamics may be fine, but cleaning up the underside, even at the rear, can optimize the entire aerodynamic package.
Oct 11, 2013 4:42:53 PM
CGX car nut:
RC:
JimFlat6:
Turbo S is a lot of money, there should be no interior trim identity issues and they shouldn't just merrily throw a cosmetically blemished tire onto a new $$$$$$$ car either. Also look at the image that shows the "road" side of the engine. The electrical wire lead, its plug and receptacle are not covered by a boot. Its just left exposed to the elements. Dumb.
The tire is not really an issue, this happens pretty often and Pirelli is to blame, not Porsche. Pirelli guarantees a certain quality and Porsche just makes random quality checks on supplier parts as far as I know. This is a procedure similar to most car manufacturers worldwide.
The "open" electrical wire lead is, according to the information I got, no issue. Before something hits the wire lead, it will hit metal and/or a rubber duct before that , so no issue here. The part itself needs to be easily accessible.
No 911 Turbo has an engine cover, not even the very expensive 997 GT2 RS. Never has been an issue, aerodynamics are just fine and damage is unlikely, unless you lower the car (which of course isn't really recommended).
--
RC (Germany) - Rennteam Editor Porsche 991 Turbo S, Cayenne GTS (958), BMW X3 35d (2013)
The aerodynamics may be fine, but cleaning up the underside, even at the rear, can optimize the entire aerodynamic package.
Well, since Porsche has its own wind tunnel on-site in Weissach with which it carries out its aerodynamic development work and has already taken the trouble to develop underbody cladding for the whole underside of the car as far back as the engine, it would appear to be a safe bet that the company's aerodynamics experts didn't suddenly stop there without looking into whether extending the cladding rearwards wouldn't lead to further improvements?
fritz
993Targa:
Strang that it's not on the Turbo? Must be cooling issues?
The GT3 does not have two exhaust gas turbine housings which need to shed a lot of heat, so omitting the cladding under them on the Turbo will be a matter of promoting air flow around them to avoid cooling issues.
fritz
Oct 11, 2013 6:53:12 PM
fritz:
993Targa:
Strang that it's not on the Turbo? Must be cooling issues?
The GT3 does not have two exhaust gas turbine housings which need to shed a lot of heat, so omitting the cladding under them on the Turbo will be a matter of promoting air flow around them to avoid cooling issues.
Aren't the turbine housings water-cooled? There's always an issue of cooling the compressed air charge, and that is via the intercoolers, and handled with the rear side vents.
If the Porsche aerodynamicists used an engine pan for the rear diffuser on the GT3, that same system should be part of the Turbo aero package.
Porsche's decision reeks of cost-cutting measures, which is inexcusable for any Porsche, especially for one as expensive as this car.
Oct 11, 2013 7:55:49 PM
CGX car nut:
fritz:
993Targa:
Strang that it's not on the Turbo? Must be cooling issues?
The GT3 does not have two exhaust gas turbine housings which need to shed a lot of heat, so omitting the cladding under them on the Turbo will be a matter of promoting air flow around them to avoid cooling issues.
Aren't the turbine housings water-cooled? There's always an issue of cooling the compressed air charge, and that is via the intercoolers, and handled with the rear side vents.
If the Porsche aerodynamicists used an engine pan for the rear diffuser on the GT3, that same system should be part of the Turbo aero package.
Porsche's decision reeks of cost-cutting measures, which is inexcusable for any Porsche, especially for one as expensive as this car.
No they are not, and they give off far more heat than could be carried away by the air which could be flowed through a couple of vents cut into a cladding panel a la GT3. In view of this, your other two points are redundant.
fritz
I've always been very impressed with the Porsche aero engineering (and other aspects). The cars are slippery with a low drag coefficient but also very stable at speed. If they decided that the Turbo is OK without an under-tray then I would trust them
Gen II Cayman S
More photos. We had a wonderful day today and all I can say is that I haven't met anyone who could pass me , not because of the lack of trying. Got some thumbs up from...motorcyclists, which is the biggest honor for me. Enjoy.
Oil consumption? Well...none. Yet.
22.1 l / 100 km fuel consumption. Ouch. This happens when you toy around with motorcycles, various 911 (incl. 997 Turbo S), RS6 (new model), M6 (new model), tons of Boxsters and Caymans (they tried... ) and other cars whose drivers probably will be frustrated today.
Lake Ammer (Bavaria), enjoying cruising in a speed limited zone.
People seem to love the red leather, I got a lot of compliments today.
Beautiful view...Alps in background.
RC (Germany) - Rennteam Editor Porsche 991 Turbo S, Cayenne GTS (958), BMW X3 35d (2013)
Are you happy with the LED headlights?
Oct 14, 2013 1:13:30 AM
Oct 14, 2013 2:33:05 AM
Awesome pics, keep em coming !
In terms of acceleration, any significant difference from your old 997 Turbo?
2014 991 Turbo (on order, Nov Prod) 2012 991 C2S w/Fabspeed SOLD 2011 Ferrari 458 Italia Rosso Mondiale / cuoio 2011 Turbo S Cab SOLD 2010 BMW AH7 2010 Caddy Escalade 2006 Cayman S First P car, SOLD
RC, you must be in car heaven with those red seats and oversized hips of the Turbo.
Are you still going for the black wheels? I think they would make your S even more perfect.
Enjoy it and keep sharing those pics.
If I don't fly, I drive my .:RS
Thanks, guys.
To answer a couple of the questions:
1. I cannot find my Performance Box (oh boy...wives), I assume my wife threw it away or one of the craftsmen working in our garage a couple of weeks ago took it. I had a couple of other gear in the garage (I keep it there because I usually need it once or twice per year), incl. a Hero cam but only the Performance Box seems to be gone. I will look for it next weekend, maybe it is somewhere but I already looked the day before yesterday and it was nowhere to be found. I will get a new one, no doubt about it but since I cannot buy it locally, it may take a week or two until it arrives. Let's just hope the weather will be good enough for some trial runs. If not...next spring.
2. The license plate is indeed very short (and special).
3. The license plate holder is actually the regular one, cut down to fit the shorter license plate. I will get a Swiss license plate holder when I am at my dealer for the winter wheels exchange around November, so it will look better then.
4. I am very happy with the LED lights. At night, the light is amazingly good. I usually put the lights into "P" mode (auto mode), so the lights adapt to traffic. Works quite well.
5. I don't remember my 997 Turbo too well but I remember the 997 Turbo S I drove in comparison a while ago and two things are obvious: Throttle response/turbo lag (excellent throttle response, basically no turbo lag) and sound (the 991 sounds really good over 3000 rpm and even better in the higher rev range over 6000 rpm). Also, the higher rev limiter makes more difference than I thought it would but one really needs to experience this first hand to understand. It is difficult to explain. This may be interesting for 997 Turbo S owners: From 240 kph on, the 991 Turbo S has 1.2 bar boost pressure all the way up and the raised overboost time also seems to make a difference. So far, I haven't noticed that the overboost actually shuts off, even after 20 seconds.
6. I don't think I will paint the wheels in black, I actually think that the silver/black of the Turbo S rims goes very well with the agate grey exterior. I will think about it when I need a tire replacement but so far, I am happy with the silver/black of the OEM rims.
7. I drove with the driver window cracked open (aprox. 20%) most of the time, up to speeds of 150 kph and I haven't noticed any buffeting noise. Even if the sunroof is open, there doesn't seem to be any buffeting noise. In the past, I usually cracked open the co-passenger window to reduce that noise. Speaking of sunroof: I have the glass sunroof and why I think it looks great, the opening is pretty small for a sunroof, which was a surprise. I wish the glass would move further to the back but I guess it has technical reasons it doesn't.
Funny: I met a silver Porsche 991 when I took the photos, it was a Weissach test car (LB-XX). When he saw the camera, he stopped far away (I thought he is enjoying the view) and only drove past me when I entered the car. Stupid me, I didn't realize it was a factory test car until the car actually drove by. "Meeting" this Weissach car was a little bit unusual since I was aprox. 300 km away from Stuttgart. I guess Porsche test drivers enjoy nice weather too (it was Sunday, so no reason for being there).
--
RC (Germany) - Rennteam Editor Porsche 991 Turbo S, Cayenne GTS (958), BMW X3 35d (2013)