Quote:
MMD said:
Quote:
Dan L said:

MMD,--I flat ran out of time to price check that set up at the factory but have been told that there MAY be an issue with that setup fitting on the PCCB equipped cars. Any insight? Maybe some evening I can get you to measure your inside diameter with some calipers. I'm of the impression that the PCCBs may be too big to fit that 996 spare.

Dan



Fits both black calipers and red calipers (front and back) on the 997.

Don't know about the PCCB, I

I guess there is a good chance it will fit because the rim of the spare MIGHT be the same ID as the 19 inch wheel.

Good question though... . If I were near the car I'd run out and give it a quick measure... . If you didn't have "official" confirmation from Porsche, you'd really need to try it on your actual wheel though... . I was told if it clears the calipers it's fine, even by a tiny 2-3 mm, you're only going 50-60 mph on the spare anyway.








thanks for the measurements. will attempt to do a fit check here sometime.

Dan